## Agreement Methods Meaning

Bland-Altman plots are widely used to assess the agreement between two instruments or two measurement techniques. Bland-Altman plots identify systematic differences between measures (i.e. fixed pre-stress) or potential outliers. The average difference is the estimated distortion, and the SD of the differences measures random fluctuations around this average. If the average value of the difference based on a 1-sample-t test deviates significantly from 0, this means the presence of a solid distortion. If there is a consistent distortion, it can be adjusted by subtracting the average difference from the new method. It is customary to calculate compliance limits of 95% for each comparison (average difference ± 1.96 standard deviation of the difference), which tells us how much the measurements were more likely in two methods for most people. If the differences in the average± 1.96 SD are not clinically important, the two methods can be interchangeable. The 95% agreement limits can be unreliable estimates of population parameters, especially for small sampling sizes, so it is important to calculate confidence intervals for 95% compliance limits when comparing methods or evaluating repeatability. This can be done by the approximate Bland and Altman method [3] or by more precise methods.

[6] Also referred to simply as a „common method,“ this principle represents only the application of methods of concordance and difference. Ronald Reagan approved the agreement and the USTR reviewed Korean practices until the end of his term. The right question: before adopting a new method; We need to make sure that it works. In other words, we would like to know if the new method can replace the standard method. The theoretical dilemma begins with statisticians` habit of drawing the data to get the feeling of the data. Because the diagram is designed; For bivariate data, correlation/regression analysis is intuitive. Unfortunately, many of us do not understand that correlation/regression is a measure of association and not of agreement. An excellent assignment can be obtained if the data is grouped around any straight line, but the agreement is only good if it is grouped around the capital line (Y-X).

Since both methods measure the same amount, we theoretically expect a good association. For obvious reasons, the conclusion of such an agreement would have required the presence and signature of both candidates. For a property to be a necessary condition, it must always be present when the effect is present. Since this is the case, we are interested in examining cases where the effect is present and to learning about the characteristics that exist and are absent under the „possible necessary conditions.“ Obviously, the properties missing if the effect is present cannot be necessary conditions for effect. This method is also generally described in comparative policy as the most diverse conception of the system. Symbolically, the method of the agreement is as follows: in November 2014, this agreement was extended for four months, with some additional restrictions for Iran. Mridula Madiyal et al., compared assay Performance of ELISA and Chemiluminescence Immunoassay when detecting antibodies against hepatitis B surface antigen [12]. The authors mentioned the Bland-Alman analysis in the methods section without mentioning the results of the Bland-Altman analysis in the summary. In addition, the authors correctly identified a trend in the Bland-Altman plot, without calculating the altered confidence limits.